Floodstop for water heater manual

1. Step 4 instructs you to install the FloodStop Valve between the rigid water line coming off the manual cold water valve and the water heater. Most rigid lines will be copper. Evaluate your line and determine which size adapter fitting you will need. Then determine what size union you will need between the FloodStop Valve and the water heater. side of the valve is pointing to the water heater. Install the FloodStop Valve between the rigid water line coming from the manual cold water valve and the water heater. NOTE: The FloodStop Valve should be installed within 2 feet of the water heater so that the Leak Sensor can lay flat on the floor. 4. Cold Water Heater Kit - FEATURES. FloodStop water leak detection system, please read this manual thoroughly. PLEASE READ CAREFULLY BEFORE PROCEEDING: If a leak is detected, the FloodStop Valve will shut off the water going to the water heater. This will stop the continuous flow of .

1. Step 4 instructs you to install the FloodStop Valve between the rigid water line coming off the manual cold water valve and the water heater. Most rigid lines will be copper. Evaluate your line and determine which size adapter fitting you will need. Then determine what size union you will need between the FloodStop Valve and the water heater. side of the valve is pointing to the water heater. Install the FloodStop Valve between the rigid water line coming from the manual cold water valve and the water heater. NOTE: The FloodStop Valve should be installed within 2 feet of the water heater so that the Leak Sensor can lay flat on the floor. 4. Cold Water Heater Kit - FEATURES. Wire harness for any FloodStop unit with two valves. Valve wires are 72" long. Replacement motor for all FloodStop valves. (Currently Sold Out). Extra Wireless Water Sensor Kit. This unit is used with the FloodStop wireless whole house units, and includes the module, sensor pad and wall adaptor.

Water Heater Kit Installation 1. www.doorway.ru o˜ main water supply valve. 2. Open faucet nearest water heater to relieve water pressure. 2. 3. Shut o˜ the manual cold water valve that supplies water to the water heater. Note that the top of the water heater will usually be marked “Cold” or “Inlet”. Position the FloodStop Valve so that the arrow on the side of the valve is pointing to the water heater. Install the FloodStop Valve between the rigid water line coming from the manual cold water valve and the water heater. 1) Shut off/close the water supply at the existing manual shutoff valve. 2) Remove the existing supply line from the manual shutoff valve. 3) Connect the FloodStop valve downstream of the manual shutoff valve (as close to the manual shutoff valve as possible). 4) Connect the water supply line to the outlet side of the FloodStop valve, which leads to the appliance.