Hks boost controller evc-s manual

EVC-S can control up to kPa (36PSI) Simple Boost Setting Directly input simple values to modes A and B, and let the HKS EVC control the boost. Return Function The boost setting returns to the factory setting when the power is turned off. On some vehicles, the boost value may be lower than the boost before installing the EVC-S. 2 Mode Boost Setting Function. HKS EVC 6 Electronic Boost Controller AK The HKS EVC has improved boost stability for maintaining pressure at high RPMs providing increased top-end power, and a new mapping feature allows boost pressure to be precisely tuned for throttle + RPM (or vehicle speed). EVC-S can control up to kPa (36PSI) Simple Boost Setting Directly input the desired boost value to modes A and B, and let the HKS EVC control the boost. Return Function The boost setting returns to the factory setting when the power is turned off. On some vehicles, the boost value may be lower than the boost before installing the EVC-S. 2 Mode Boost Setting Function.

When using an HKS FCD, a fuel controller may be required for additional fuel tuning. Read this instruction manual prior to installation to ensure safe and correct usage and optimal product performance, HKS EVC Introduction －1－ The HKS EVC enables the adjustment of the boost setting from inside the vehicle. Park the vehicle in a safe place when adjusting the EVC. (1) Decide on a target boost setting for Mode A and Mode B. Example: Mode A PSI, and Mode B PSI. (2) Make sure the of volume knob A is red. If it's green, press the (PWR/SEL) button once. 4 (3) Lightly press volume knob A to pop up the knob. Turn the knob full counter-clockwise. Description HKS EVC-S Boost Controller. Small on size but big on features that matter, the EVC-S is the no frills boost controller from HKS. Featuring a solenoid valve that accurately measures boost up to kPa (36PSI), the EVC-S can store two boost level settings as well as parameters for offset and boost response.

following: With "Low' and "Set" flashing, turn the EVC's volume knob counterclockwise until the display reads , then press "Sbc". Enter and press "Sbc" again. Drive the vehicle under full boost in third gear and read the boost pressure once it stabilizes. This figure is your stock boost. Reset the EVC unit (see directions on the next page). EVC-S can control up to kPa (36PSI) Simple Boost Setting Directly input simple values to modes A and B, and let the HKS EVC control the boost. Return Function The boost setting returns to the factory setting when the power is turned off. On some vehicles, the boost value may be lower than the boost before installing the EVC-S. 2 Mode Boost Setting Function. EVC-S can control up to kPa (36PSI) Simple Boost Setting Directly input the desired boost value to modes A and B, and let the HKS EVC control the boost. Return Function The boost setting returns to the factory setting when the power is turned off. On some vehicles, the boost value may be lower than the boost before installing the EVC-S. 2 Mode Boost Setting Function.